Date Registered: 02-2004 Location: Panania, Sydney TOTAL POSTS:2706
|
Re: Revhead's Mota
quote:
Revhead Kev wrote:
Just added my 10LED bargraph rear-wheel torque meter to the list of mods now that it has been calibrated and tested.
So where are the photos showing the gauge installed?
I looked at the Silicon Kit magazine website (mentioned in the relevant thread) but you need to subscribe to read the entire article... I don't think RCS Electronics are still @ Bexley anymore...
--- Rich. X-013(c)
'04 S2 ST Auto. Nudge_roofracks_tow_tints_Lightforce_GME_BFG_TBS_home-made-bashplate_50mm-spacer-lift
Click here to see >300MB of photos and videos All For His Glory.
Date Registered: 10-2006 Location: Mona Vale, Sydney, AUSTRALIA TOTAL POSTS:2953
|
Re: Revhead's Mota Only 5 steps to happiness
1. Fit full Hitech stainless exhaust with extractors - DONE 2 yrs ago
2. Buy and fit CAI with bypass valve
3. Fit Haltech Minceptor piggy-back
4. Fit Liquid Injection LPG conversion
5. Fit 50mm strut spacers
Date Registered: 02-2004 Location: Panania, Sydney TOTAL POSTS:2706
|
Re: Revhead's Mota Actually that would be steps 1.5, 2.5, 3.5, and 4.5
Then I propose a Step 7 would be to fit a 50-shot NOS kit!!! (of course with the obligatory before-and-after dyno runs).
--- Rich. X-013(c)
'04 S2 ST Auto. Nudge_roofracks_tow_tints_Lightforce_GME_BFG_TBS_home-made-bashplate_50mm-spacer-lift
Click here to see >300MB of photos and videos All For His Glory.
